Create an SMLT from an Existing MLT

Before you begin

  • Create an MLT before you create a split in the MLT.

  • To create an SMLT from an existing MLT, first shut down the MLT ports. Configure the MLT as SMLT, and then enable the ports again.

    Important

    Important

    Failure to perform this operation can lead to ports in STP blocked state and traffic loss.

  • If you are configuring SMLT with vIST, all the SMLT VLANs associated with vIST must have an I-SID.

About this task

Create an SMLT from an existing MLT to split physical ports between two switches to improve resiliency and provide active load sharing.

Important

Important

To remove an SMLT configuration from the MLT on a vIST switch, first shut down the SMLT MLT ports on its vIST peer.

Failure to perform this operation can lead to Layer 2 loops.

Procedure

  1. Log on to the MLT Interface Configuration mode:

    enable

    configure terminal

    interface mlt <1-512>

  2. Create an SMLT from an existing MLT:

    smlt

Example

Create an SMLT on MLT 1:

Switch:1(config)#interface mlt 1
Switch:1(config-mlt)#smlt